User Login

DI-1000U-5V Wiring for Sensors with 0-5V DC Output

Connect the sensor as shown below in the following diagram. Please make sure to solder the sensors leads into the adapter board as shown below. Do not connect directly to the terminal block.

Note: The following settings are required for the 0-5V sensor to function correctly and to be detected by SensorVUE/ControlVUE software.

  • For displacement sensors (LVDT), the ID setting must begin with "DISP-", e.g. "DISP-1234"
    Type "ID DISP-xxx<Enter>" in the terminal software.
  • For pressure sensors, the ID setting must begin with "PRESS-", e.g. "PRESS-1234"
    Type "ID PRESS-xxx<Enter>" in the terminal software.
  • For other types of sensors, please contact Loadstar Sensors
  • The GAIN value on the DI-1000 must be set to 1.
    Type "GAIN 1<Enter>" in the terminal software.

DI-1000-5V Wiring for 0-5V Sensor